Power distribution and transformers
Transformers, panelboards, switchgear and feeders: how power is distributed and protected inside a plant.
Latest articles
How-to
How many 480 V fixtures on a 30 A three-pole breaker
Fifteen 2.4 A fixtures fit on a 30 A three-pole 480 V breaker: five each on A-B, B-C and C-A draw 20.8 A per line, under the 24 A continuous-load limit, because a three-pole breaker's pole ratings never add.
Comparison
Switchgear vs MCC: what each term actually means
The terms mark different equipment: a low-voltage MCC is a UL 845 assembly of stab-in buckets — motor controllers to NEMA size 4, 100 hp at 460 V, feeder frames to 250 A — while switchgear is UL 1558/ANSI C37 distribution gear. A 5.5 kV metal-clad lineup with starters in its draw-out breaker compartments is switchgear with integrated motor control; document it that way.
How-to
Powering a 600 V three-phase machine from 240 V single phase
The nameplate works out to 20.8 kVA of apparent power. Fed from the single-phase shop service, that is about 87 A before converter and transformer losses, so the machine needs a rotary phase converter sized to its total demand plus a reverse-connected step-down transformer, unless tracing shows the internals run on 200 to 220 V. Verify loaded voltage balance before releasing the machine to production.
Explainer
Evaluating dry-type transformer hot spot temperature rise
A 128.2°C average winding rise proves only the average, not the hot spot: the resistance method and a point RTD measure different quantities, so the 219°C combination is invalid. The 202.6°C full-load reading is a 180.8°C local rise, which projects to 220.8°C at the 40°C rating ambient and exceeds the 180°C hot-spot rise a class 220 system allows. Decision: run the simultaneous full-voltage, full-load heat run.
How-to
Fixing voltage drop on a long 277 V lighting feeder
The drop budget on this feeder limits the loop to 0.40 Ω — 0.267 Ω per conductor — so size up the copper or split the load across the three phases of the wye system, which relaxes the limit sixfold. Raise the source only after the two-endpoint check, because a fixed boost that fixes full-load voltage also overvoltages the panel at light load.